Page
24
LTO SCSI Interface Manual
Field
Bytes
Bits
Description
Sync
7
4
Always 1, indicating Synchronous Transfer is supported.
Linked
7
3
Always 0, indicating Linked Command is not supported.
TransDis
7
2
Always 0, indicating Transfer Disable is not supported.
CmdQ
7
1
Always 0, indicating Command Queuing is not supported.
VS
7
0
Vendor
Identifica-
tion
8-15
8 bytes of ASCII data: “SEAGATE” followed by 1 space.
Product
Identifica-
tion
16-31
16 bytes of ASCII data: “ULTRIUM06242-XXX“.
Product
Revision
Level
32-35
4 bytes of ASCII data indicating the SCSI firmware version.
Vendor
Specific
36-55
This field may contain additional vendor specific information.
Obsolete
Always 0
Reserved
Always 0
The Standard Inquiry Data is based on the SCSI 3 standard for Standard Inquiry
Data. This allows for setting certain bits in byte 6 to indicate features that were non-
standard in SCSI 2. The only supported SCSI 3 field is Multi Port (MultiP).
The Multi-Port (MultiP) flag is set if the device has multiple interface ports. Parallel
SCSI devices will not have multiple interface ports and will have this flag clear. Fibre
Channel devices will have multiple interface ports and will have this flag set.
The 16 Bit Address (Adr16) and Wide Bus 16 (WBs16) flags are set depending on
whether the hardware supports these bus features. These flags are only valid for
parallel SCSI and are clear for all other low level interfaces.
Supported Vital Product Data (VPD) Page (00h)
The Supported Vital Product Data Page lists the following eleven VPD pages
including itself.
Supported Vital Product Data Inquiry Page
Byte
Bits
7
6
5
4
3
2
1
0
0
Peripheral Qualifier
Peripheral Device Type
1
Page Code
2
Reserved
3
Page Length
4
Supported Vital Product Data Page Code
5
Unit Serial Number Page Code
6
Device Identification Page Code
7
SCSI Firmware Revision Page Code
8
Servo Firmware Revision Page Code
9
Head Assembly Serial Number Page Code
10
Reel Motor 1 Serial Number Page Code
11
Reel Motor 2 Serial Number Page Code
