Seagate ST9816AG, Руководство по установке

Страница: 9 / 28

4. Reboot your computer again using the blank, bootable diskette.
5. You should now be able to access the software on your new
hard disc. If your new hard drive is drive C, type c:\seamove
to transfer the disc support software. Use a different drive
letter if necessary.
The SEAMOVE program transfers the drive-support files from
your new hard disc to your blank, bootable diskette in drive A.
After all the files have been transferred, SEAMOVE deletes
all the files from the hard drive, along with the temporary
partition that held them. You must then run Disk Manager from
your bootable software diskette to access the full capacity of
your drive.
Configuring your system BIOS
1. Restart your computer (again!) from a bootable diskette, and
enter your system setup program as described previously.
2. Within the system setup program, make sure that the correct
drive type is listed for each ATA hard drive in your computer.
Some newer computers can automatically determine drive-
type characteristics if you select the
Auto drive-type setting.
If your computer does not provide this option, you must
manually enter the number of
cylinders, heads and sectors
per track for your new drive, as shown in the table below.
Cylinders 1,571
Heads 16
Sectors per track 63
Total sectors 1,583,568
Bytes per sector 512
Capacity 810.7 million bytes
Marathon 810 Installation Guide, February 1996 7