Seagate Kinetic HDD Product Manual, Rev. B
16
3.0
C
ONFIGURING AND
M
OUNTING THE
D
RIVE
This section contains the specifications and instructions for configuring and mounting the drive.
3.1
H
ANDLING AND
S
TATIC
-D
ISCHARGE
P
RECAUTIONS
After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic discharge (ESD)
hazards. Observe the following standard handling and static-discharge precautions:
3.2
D
RIVE
M
OUNTING
Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the
bottom- mounting holes. Refer to Figure 3.2.1 for drive mounting dimensions. Follow these important mounting
precautions when mounting the drive:
• Allow a minimum clearance of 0.030 inches (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.150 inches (3.81mm) into the bottom or side mounting holes.
• Do not over tighten the mounting screws (maximum torque: 6 inch-lb).
Caution
• Before handling the drive, put on a grounded wrist strap. Wear a grounded wrist strap throughout
the entire installation procedure.
• Handle the drive by its edges or frame
only
.
• The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.
• Always rest the drive on a padded, antistatic surface until users mount it in the computer.
• Do not touch the connector pins or the printed circuit board.
• Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal
voids the warranty. Some factory-installed labels contain information needed to service the drive.
Other labels are used to seal out dirt and contamination.
Weight:
608g (1.34 lb)
Note
These dimensions conform to the Small Form Factor Standard documented
in SFF-8301 and SFF-8323 found at
