Seagate ST320410ACE, Руководство по эксплуатации продукта

Страница: 32 / 44

24 U Series CE Family Product Manual, Rev. A
3.1.2 Identify Drive command
The Identify Drive command (command code EC
H
) transfers information
about the drive to the host following power up. The data is organized as
a single 512-byte block of data, whose contents are shown in the table
on page 25. All reserved bits or words should be set to zero. Parameters
listed with an “x” are drive-specific or vary with the state of the drive. See
Section 1 of this manual for default parameter settings.
The following commands contain drive-specific features that may not be
included in the
Draft ATA-Rev 6 Standard.
Write Multiple C5
H
Write Sectors 30
H,
31
H
ATA-standard power-management commands
Check Power Mode 98
H
or E5
H
Idle 97
H
or E3
H
Idle Immediate 95
H
or E1
H
Sleep 99
H
or E6
H
Standby 96
H
or E2
H
Standby Immediate 94
H
or E0
H
ATA-standard security commands
Security Set Password F1
H
Security Unlock F2
H
Security Erase Prepare F3
H
Security Erase Unit F4
H
Security Freeze Lock F5
H
Security Disable Password F6
H
Command name Command code (in hex)