Hawk 4 Family Installation Guide, Rev. B 31
_____________________________________________________________________________________________________________
• Verify that all connections between the drive and the
host system are correctly installed. Most cables have
a contrasting color stripe indicating pin 1. Pin 1 on the
drive I/O connector and the DC power connector are
indicated in the figures in the Initial Set-up Informa-
tion section.
• Verify option select and drive ID select jumpers and
installation of terminator enable jumper where appli-
cable. See Drive Configuration section.
Make sure there are not jumpers on both J5 and J6
drive ID select position. Use J5 or J6
but not both.
Do not power up the host system until the drive is
mounted and the system cover is replaced.
• Connect DC power connector to the drive.
• Replace the Host System cover.
• Turn on DC power.
• Boot the system from the floppy drive or from a
previously installed hard-drive if there is one.
• Proceed with drive setup of the new hard drive.
