Seagate Cheetah X15, Руководство по эксплуатации продукта

Страница: 77 / 92

Cheetah X15 Product Manual, Rev. C 67
The output characteristics shall additionally conform to EIA RS-485.
Figure 24. LVD output signals
Input characteristics
Each signal (Vs) received by LVD interface receiver circuits shall have the following input characteristics when
measured at the disk drive connector:
Steady state Low level output voltage* = 0.030 V = < V
s
= < 3.6 V (signal negation/logic 0)
Steady state High level output voltage* = –3.6 V = < V
s
= < –0.030 V (signal assertion/logic 1)
Differential voltage = +0.30 V minimum with common-mode voltage ranges 0.700 V = < V
cm
= < 1.800 V.
(X3T10/1142D revision 13, p. 152)
*These voltages shall be measured between the output terminal and the SCSI device’s logic ground reference.
Input characteristics shall additionally conform to EIA RS-485-983.
Figure 25. Typical SE-LVD alternative transmitter receiver circuits
9.7.1.1 Single-ended drivers/receivers
The maximum total cable length allowed with drives using single-ended I/O driver and receiver circuits
depends on several factors. Table 19 lists the maximum lengths allowed for different configurations of drive
usage. These values are from the SPI-3 document. All device I/O lines must have equal to or less than 25 pf
capacitance to ground, measured at the beginning of the stub.
Signal —
LVD Differential
Driver
1.55V
V
0
= True / Logic 1 / Assertion
—15ma
.95V +15ma
Signal —
LVD Differential
Driver
.95V
V
0
= False / Logic 0 / Negation
|V
0
| = .6V
+15ma
1.55V —15ma
VCCA VCCB
Single
Ended
Circuitry Single
Ended
Receiver Single
Ended
Negation
Driver
Single
Ended
Assertion
Driver
Single
Ended
Ground
Driver
Single Ended:
LVD:
LVD Signal Drivers
LVD Signal Drivers
LVD
Receiver
Ground
GND
+Signal
—Signal
—Signal