Seagate CHEETAH 9 ST19101DC, Руководство по установке

Страница: 25 / 56

Cheetah 9 Installation Guide, Rev. B 23
Figure 2. SCSI bus termination
Terminator power
You usually will not need to change this option and can normally
leave the drive configured as it was shipped from the factory. For
information about how to change the terminator power option on
your drive, refer to the appropriate drive-specific section.
I/O circuits and data path widths
• “WD” and “DC” models use differential I/O circuits. You cannot
mix these models with single-ended models (“N,” “W,” “WC”)
on the same SCSI bus. The circuits are incompatible with
each other.
• “W,” “WD,” and “WC” models have a “wide” (16-bit) SCSI data
bus rather than the standard (non-wide) 8-bit SCSI data bus;
however, you can use these wide drives on a standard (non-
wide) 8-bit data bus.
Internal
SCSI device
Internal
SCSI device
Controller
External
SCSI device
External
SCSI device
External
SCSI
cable
Internal SCSI cable
Terminate
Internal
SCSI device
Internal
SCSI device
Controller
Internal SCSI cable
Terminate