Seagate Cheetah 18, Руководство по установке

Страница: 21 / 52

Cheetah 18 Installation Guide, Rev. A 19
Initial setup information
The general information beginning on this page applies to all of
the Cheetah 18 drive models. After reading the general informa-
tion topics, refer to the appropriate drive-specific section listed
below for additional information about configuring and installing
your particular model.
Drive models Page
ST118202LW 39
ST118202LC 45
General information
The following general information topics are discussed:
• Single-ended and low voltage differential modes
• SCSI ID jumpers
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
1
• Formatting the drive
1
This mounting procedure does not apply to “LC” model drives.
To mount an “LC” drive, plug the drive into the system’s single
connector attachment (SCA) position on the system’s back
panel.