Seagate Barracuda Pro ST10000DM001, Руководство по эксплуатации продукта

Страница: 29 / 53

Seagate BarraCuda Pro Serial ATA Product Manual, Rev. A 28
www.seagate.com Serial ATA (SATA) interface
Notes:
1. All pins are in a single row, with a 1.27mm (0.050”) pitch.
2. The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the
mating sequences are:
• the ground pins P4 and P12.
• the pre-charge power pins and the other ground pins.
• the signal pins and the rest of the power pins.
3. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a
blind-mate backplane configuration.
4. All used voltage pins (V
x
) must be terminated.
1.4.3 Supported ATA commands
The following table lists Serial ATA standard commands that the drive supports. For a detailed description of the ATA
commands, refer to the Serial ATA: High Speed Serialized AT Attachment specification
. See “S.M.A.R.T. commands”
on page 51 for details and subcommands used in the S.M.A.R.T. implementation.
Table 12 Supported ATA commands
Command name Command code (in hex)
Accessible Max Address Configuration
Get Native Max Address Ext 78
H
/ 0000
H
Set Accessible Max Address Ext 78
H
/ 0001
H
Freeze Accessible Max Address Ext 78
H
/ 0002
H
Check Power Mode E5
H
Configure Stream 51
H
Download Microcode 92
H
Execute Device Diagnostics 90
H
Flush Cache E7
H
Flush Cache Extended EA
H
Get Physical Element Status 12
H
Identify Device EC
H
Idle E3
H
Idle Immediate E1
H
Read Buffer E4
H
Read DMA C8
H
Read DMA Extended 25
H
Read FPDMA Queued 60
H
Read Log DMA Ext 47
H
Read Log Ext 2F
H
Read Multiple C4
H