Removing rear grille and Propeller to remove obstruction
1. Remove the SEASCOOTER
™
from the water.
2. Make sure the master switch is off.
3. Remove the battery - see page 13, step 1-9.
4. Unscrew the six rear grille screws as shown in figure 16.
23
22
Fig.15
Fig.14
1
2
Fig.16
Fig.17
5. Whilst holding the Propeller, use an M6 socket to
remove the nut from the Propeller shaft (See figure 17).
6. Slide the Propeller off the shaft, taking care not to loose
the drive pin or washers.
7. Remove the blockage from the Propeller.
8. Replace the drive pin (if removed), see figure 18, and
Propeller. Turn the Propeller slowly until you locate the
pin and push the Propeller fully on.
