C
HARGING
P
ROCESS
10
- Seacraft Li-Ion Battery Charger 240 / 400 Manual KP240J9S / KP400A9S
Note
If the charging process is longer than usual and the color change of LED2 to green
does not occur, then the charging process may not be successful and should not be
continued without diagnosing the problem.
The charging process should be carried out in a ventilated, dry venue at a temperature
range of 10/+40
⁰
C.
End of charging (100%) occurs after the color of LED2 changes to green.
However, keep in mind that charging to 80% is much faster.
Not using the full charge / discharge range increases the durability of lithium
batteries.
If the battery charger is not working properly check the following list:
•
Are the battery and charger connected properly?
•
Is the battery and charger voltage range correct?
•
Is the battery in „protected” state?
•
Is the battery overheated?
•
Is the battery level too low to start the charging process?
•
Is the charger’s fuse blown?
After analysing the problem and eliminating it, the charger must be disconnected for at least
30 seconds from the battery and mains power supply and then restarted in the correct order
as
specified in the above instructions. Contact your supplier if the problem persists.
C++ C++ C++ C++ C++ C++ C++ C++ Caution
In order to preserve the long life of the electrolytic capacitors, the charger must be
connected to the mains power supply for at least 10 minutes every 2 months.
