11
English
B U L B R E P L A C E M E N T
Unscrew the torch and extract the inner battery pack.
Unscrew the torch and extract the inner battery pack.
Extract the bulb and insert the new one (avoid touching it with your hands by
using a cloth).
Reinsert the whole making sure that the bulb fits in the hole of the parabola.
Close the torch.
M A I N T E N A N C E
It is essential to follow the following instructions: always carry the torch inside a bag
protecting it or in the hard case supplied. Prevent shocks. Prevent prolonged exposure
to sunrays. At the end of each dive (Sea, Lake, or Swimming Pool) always rinse in
fresh water and wipe. Check the state of the O-ring every time the body is opened.
Clean and lubricate it with silicone grease.
We recommend to have the product inspected every year by an authorized SEAC
SUB center.
O P T I O N A L S
10 and 20 W / 6 V Bulbs, G4 mount, for SEARAY PLUS 20 torch
20, 35 and 50 W / 12 V Bulbs, G6 mount, for SEARAY PLUS 50 torch
T E C H N I C A L S P E C I F I C AT I O N S O F A U T O M AT I C B AT T E RY C H A R G E R
F O R N i - C d / N i - M h B AT T E R I E S
Model M706B supplied with SEARAY PLUS 20 W Torch
Model M706C supplied with SEARAY PLUS 50 W Torch
The model number is on the label placed on the battery charger. Before recharging
your torch, please check the correspondence between battery charger and torch.
C A U T I O N
NON observance of these instructions may cause irreparable damage to the battery pack
U S E
Check that the torch switch is in OFF position.
Supply with battery charger mod. M706C: supply the battery charger with 220V.
The green LED lights up. If you connect the plug with the battery of the torch the red
LED must also light up to indicate that it is charging; at the end of the charging the
red LED will go out leaving only the green LED on and into the battery only a modest
holding current will flow.
Supply with battery charger mod. M706B: supply the battery charger with 220V.
NO LED lights up. If you connect the plug with the battery of the torch the red LED
must also light up to indicate that it is charging; at the end of the charging the red
LED will go out leaving only the green LED on and into the battery only a modest
holding current will flow.In case of over-discharged battery (voltage lower than
0.4V/element), the battery charger will automatically supply at start a low smoothing
charge; when the voltage of 0.6v/element has been reached, the actual recharging
will start.
The time needed to reach full charge will be more or less long as a function both of
the battery rated capacity and of the charge quantity still present in it. PLEASE
OBSERVE THE MIN. AND MAX. CAPACITIES SPECIFIED.
