10
STANDARD INSTALLATION
Fig. 9
* For 24V operators (SURF or SURF K) use 2 x 2,5 cables type to connect them to the control unit
1
1
2
2
3
4
5
6
7
8
9
10
10
11
2x1
4x1
4x1,5 *
2x1
4x2,5
4x1
1xRG58
4x1
4x1,5 *
Fig. 10
2x1,5
EXIT
ENTRY
1) Operator
2) Mechanical stop
3) Electronic control unit
4) Flashing lamp
5) Right Photocell (Dx)
6) Differential switch 16A - 0,03A
7) Left Photocell (Sx)
8) Start/Stop push button with key
9) Antenna
10) Support for photocells
11) Warning notice
Mechanical
stop
in closing
Mechanical
stop
in opening
GATE ARRANGEMENT
Some checks on the gate are required to verify the
operator fitting; Make sure that:
A
. the fix and the moving parts of the gate are
strong and non-deformable;
B.
the length of each leaf does not exceed the
length propped-up by the operator type (see Fig. 6)
C.
the weight of each leaf does not exceed the
weight propped-up by the operator type (see Fig. 6)
D.
the hinges and the general structure must be in
good conditions and able to support the operator
thrust; the gate must move smoothly throughout its
whole travel;
Where possible, it is advisable to install
mechanical stops on the ground for the better
functioning of the operator
