SEA Setronik1 Restyling, Руководство пользователя

Страница: 67 / 99

SEA SYSTEMS
INSTALLATION AND USE
STK1R control panels (Setronik1 Restyling)
STK1R-EN-62-0-A
rev0
24/01/2019
Virtual outputs table
DG56 [6.
XX
.1] V
IRTUAL OUTPUTS
(
OUTPUT FUNCTIONS
)
00 Reserved
01 Door 1 opening command
02 Door 2 opening command
03 Door 1 closing command
04 Door 2 closing command
05 Car light 1. See also timer 4.45
06 Retiring cam. See also timers 4.49 and 4.50
07 Reserved
08 Reserved
09 Soft stop valve command (upward only)
10 Star-delta starting contactor command. See also timer 4 .11
11 Reserved
12 Soft stop valve command (upward and downward)
13 Brakes command (used in “manual brake unlocking” emergency operation). See also VI.63 .
14 Exclusion of high speed soft starting resistors
15 Exclusion of low speed soft starting resistors
16 ÷ 19 Reserved
20 Speed selection bit 1 (bit 0 is the state of the AV relay on the STK1R board)
21 Speed selection bit 2
22 Reserved
23 Upward motion command for NGV-A3 valve
24 Reserved
25 VMP/2CH/S valve command (for GMV valve block type 3010/2CH/S)
26 Alarm filtering according to EN81-28. See also VI.1 , VI.93 , VI.94 .
27 ÷ 28 Reserved
29 Enable signal for VVVF drive (with parameter 1.00.0=6)
30 Reserved
31 2nd downward valve command (for hydraulic lifts with 2 valves operating in series as UCM protection means)
32 “Doorlock” valve used as UCM protection mean (see also timer 4.59 )
33 Door 3 opening command
34 Door 3 closing command
35 In-use signal
36 “Gong” signal (acoustic warning signal of imminent landing)
37 Vocal synthesis START command (see also timer 4.51 ).
38 Red light for car without door (with the safety photocell)
39 Green light for car without door (with the safety photocell)
40 Car in the door unlocking zone of the destination floor.
41 Car light 2 (see also timer 4.53 )
42÷47 Electrical interlocks unlocking commands, for the first six landings (see also timer 4.52 )
48 Car stationary at floor (used for “car at floor” indication)
49 “Get out of the car” signal, for preferential operation (see also parameter 3.xx.2 =3 or 4 and timer 4.57 )
50 Micro-levelling upward command (see also timer 4.60 )
51 Micro-levelling downward command (see also timer 4.61 )
52 Hoistway light command in inspection or firefighting operation (EN81-72)
53 Forces door closing in firefighting operation (EN81-72) (door “nudge” control)
54 Buzzer for firefighting operation (EN81-72)
55 “Out of service” signal (same as FFS output on STK1R board)
56 “In service” signal (inverted FFS output)
© 2019 Sea Systems Page 67 of 99