Sistemi elettronici
di Aperture Porte e Cancelli
1,5 mm
Fig. 11
Fig. 12
3/30
5. RELEASE SYSTEM
5.1. In order to release do as follows:
-Open the lock cover, insert the key and rotate it 90° clockwise
(Fig. 6).
- Pull the release lever until it stops, about 90° approximately
(Fig. 7).
Note: when you pull the release lever, the electronic control
unit receives a stop impulse thanks to a micro-switch
placed inside.
5.2. In order to relock do as follows:
- Push the release lever to complete closing.
- Rotate the key counter-clockwise and extract it.
- Close the protective lock cover.
Once the lock has been restored the electronic control unit
reactivates
6. GEAR RACK MOUNTING
6.1.
Release the motor reducer and take the leaf to complete
opening;
6.2.
Fix to each gear rack element the support pawls using the
appropriate lock screws, taking care to place them in the upper
part of the hole (Fig. 8) ;
6.3.
Lean the gear rack element on the toothed pinion of the
motor so that it results parallel to the ground slideway of the
gate, place it as shown in Fig. 9 and electrically weld the central
pawl B to the gate structure (Fig. 10).
6.4.
Make sure that all the gear rack elements are perfectly
aligned and placed correctly (teeth in phase). It’s suggested to
place two aligned elements infront of a third one as shown in
Fig.11;
6.5.
Repeat the above described operation for all the remaining
gear rack elements which have to be installed;
6.6.
To avoid that the door weights down on the pinion (Fig.12)
lift up the whole rack about 1,5 mm.
Warning
: Keep a gap of about 0,5 mm between pinion tooth
and gear rack tooth;
6.7.
Make sure that the gear rack works at the center of the
pinion along all rack elements, if necessary, adjust the
distance
pieces length.
Fig. 6
Fig. 9
A
B
C
Manually move the gate until pawl C is placed in
correspondence to the pinion, now fix it with electric welding.
Repeat the same procedure for pawl A after having placed it in
correspondence to the pinion;
Fig. 7
Fig. 8
Fig. 10
Open
l
C ose
cod. 67410325
REV 01 - 04/2007
ENGLISH
