GENERAL NOTICE FOR THE INSTALLER AND THE USER
1. Read carefully these
Instructions
before beginning to install the product. Store these instructions for future
reference
2. Don’t waste product packaging materials and /or circuits.
3. This product was designed and built strictly for the use indicated in this documentation. Any other use, not expressly
indicated here, could compromise the good condition/operation of the product and/or be a source of danger. SEA S.p.A.
declines all liability caused by improper use or different use in respect to the intended one.
4. The mechanical parts must be comply with Directives: Machine Regulation 2006/42/CE and following adjustments),
Low Tension (2006/95/CE), electromgnetic Consistency (2004/108/CE) Installation must be done respecting
Directives: EN12453 and En12445.
5. Do not install the equipment in an explosive atmosphere.
6. SEA S.p.A. is not responsible for failure to observe Good Techniques in the construction of the locking elements to
motorize, or for any deformation that may occur during use.
7. Before attempting any job on the system, cut out electrical power and disconnect the batteries. Be sure that the
earthing system is perfectly constructed, and connect it metal parts of the lock.
8. Use of the indicator-light is recommended for every system, as well as a warning sign well-fixed to the frame
structure.
9. SEA S.p.A. declines all liability as concerns the automated system’s security and efficiency, if components used, are
not produced by SEA S.p.A..
10. For maintenance, strictly use original parts by SEA.
11. Do not modify in any way the components of the automated system.
12. The installer shall supply all information concerning system’s manual functioning in case of emergency, and shall
hand over to the user the warnings handbook supplied with the product.
13. Do not allow children or adults to stay near the product while it is operating. The application cannot be used by
children, by people with reduced physical, mental or sensorial capacity, or by people without experience or necessary
training. Keep remote controls or other pulse generators away from children, to prevent involuntary activation of the
system.
14. Transit through the leaves is allowed only when the gate is fully open.
15. The User must not attempt to repair or to take direct action on the system and must solely contact qualified SEA
personnel or SEA service centers. User can apply only the manual function of emergency.
16. The power cables maximum length between the central engine and motors should not be greater than 10 m. Use
2
cables with 2,5 mm section. Use double insulation cable (cable sheath) to the immediate vicinity of the terminals, in
particular for the 230V cable. Keep an adequate distance (at least 2.5 mm in air), between the conductors in low voltage
(230V) and the conductors in low voltage safety (SELV) or use an appropriate sheath that provides extra insulation
having a thickness of 1 mm.
English
Rev.00 - 03/2013
8
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
67411575
Содержание LOOP 23105158
Страница 11: ......
