Fig. 19
Disc 1
Disc 2
INSTALLATION OF POSITIVE STOPS
Ø
Release the unit (as in fig. 24 of page 27)
Ø
Make the shaft come out for ¾ of its stroke
Ø
Put the positive stops into the front flange of the unit with the two tie rods (of the three present on the stops)
which are parallel to the gate (Fig.19)
Ø
Fix the positive stops with the provided screws
Ø
Ø
At this point couple the shaft to the front bracket
Ø
To adjust the positive stops in opening act on disk 1 and in closing act on disk 2.
Attention: The mounting of the mechanical positive stops does not cause the reduction of the shaft
stroke.
Insert the ball joint after having installed the stops.
rods parallel to the gate
BREATHER SCREW
Up
down
Unscrew and
remove at the
end of installation
ATTENTION
It is obligatory to remove the breather
screw at the end of the installation.
FU LL TAN K
English
English
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
Fig. 20
Fig. 21
OK
Cod. 67410845
REV 02 - 06/2009
25
