Sea Tel COBHAM, Инструкция по установке и эксплуатации, Страница: 8 / 28

Sea Tel Marine Radome Air Conditioner Installation
1-4 99-158223-A
2. Installation
This section covers the installation procedures for internally and externally mounted Radome systems. Please note
that the following instructions are intended as a general guideline only. You MUST read and refer to the antenna’s
system installation and operation manual for detailed information. Due to the nature of the equipment is it highly
recommended that you read both manuals completely before attempting to install any equipment.
2.1. Internally Mounted Units
If you are installing an internally mounted Marine Radome Air Conditioner, select a location in the 1.
dome that will not interfere with the movement of the antenna.
Internal units must be accessible and have a clear area below the dome for condenser 2.
intake/discharge openings. There must be adequate space for air flow underneath the dome’s base
pan.
Use a cutout template to mark and then cut openings in the base pan. Drill holes for mounting as per 3.
template.
Ensure that intake and discharge condenser air steams are separated with a divider so that air does 4.
not short-cycle from exhaust to intake.
Position the unit over opening and fasten unit using the provided hardware. Ensure foam seals are 5.
tightly compressed between the unit and base pan, and that there are no leaks from outside.
Install the power cord . 6.
Use a diverter to direct hot-air discharge away from the antenna. 7.
Figure 1 Internal AC Mount Example