Sea Tel 9797B-70 C-Band TX/RX, Инструкция по установке и эксплуатации

Страница: 44 / 110

Maintenance and Troubleshooting 9797B-70 C-Band TXRX
7-2
7.2.1. Check ACU Parameters
Assure that the parameters are set correctly (you may wish to record them in the Factory Default Settings, in
section 5 of this manual).
7.2.2. Latitude/Longitude Auto-Update check
Refer to the Latitude & Longitude Update check procedure in the Functional Testing section of this manual.
7.2.3. Heading Following
Refer to the Heading Following verification procedure in the Functional Testing section of this manual.
7.2.4. Azimuth & Elevation Drive
Refer to the Azimuth & Elevation Drive check procedure in the Functional Testing section of this manual.
7.2.5. Test Tracking
Refer to the four quadrant Tracking check procedure in the Functional Testing section of this manual.
7.2.6. Visual Inspection - Radome & Pedestal
Conduct a good, thorough, visual inspection of the radome and antenna pedestal. Visually inspect the inside
surface of the radome top and of the antenna pedestal. Look for water or condensation, rust or corrosion,
white fiberglass powder residue, loose wiring connections, loose hardware, loose or broken belts or any other
signs of wear or damage.
1. Radome Inspection - All the radome flanges are properly sealed to prevent wind, saltwater spray
and rain from being able to enter the radome. Re-seal any open (“leaky”) areas with marine
approved silicone sealant. If heavy condensation, or standing water, is found inside the radome,
isolate and seal the leak, and then dry out the radome. Small (1/8 inch) holes may be drilled in the
base pan of the radome to allow standing water to “weep” out.
2. Antenna Pedestal Inspection - The shock/vibration springs and/or wire rope Isolators should not be
frayed, completely compressed, or otherwise damaged. The plated and painted parts should not be
rusted or corroded. The harnesses should not be frayed and all the connectors should be properly
fastened and tightened. All hardware should be tight (no loose assemblies or counter-weights).
Replace, re-coat, repair and/or tighten as necessary.
7.2.7. Mechanical Checks
Turn the pedestal power supply OFF
1. Inspect inside of radome for signs that the dish or feed have been rubbing against the inside of the
fiberglass radome.
2. Rotate the pedestal through its full range of azimuth motion. The antenna should rotate freely and
easily with light finger pressure.
3. Rotate the pedestal through full range of elevation rotation. The antenna should rotate freely and
easily with light finger pressure.
4. Rotate the pedestal through full range of cross-level rotation. The antenna should rotate freely and
easily with light finger pressure.
5. Rotate the level cage through the full 90 degrees of rotation from CCW stop to CW stop. The level
cage antenna should rotate freely and easily with light finger pressure. Attached cables should not
cause the cage to spring back more that a few degrees from either stop when released.
6. Inspect all drive belts for wear (black dust on/under the area of the belt).
7. Inspect AZ Drive chain. IF chain is beginning to show signs of rust or corrosion, apply a light coat
of light duty oil to the chain. Wipe excess oil off to leave a light coating on the chain. DO NOT
over-lubricate .
7.2.8. Check Balance
Check the balance of the antenna, re-balance as needed (refer to the Balancing the Antenna procedure
below).