Sea Tel 5012-33, Руководство по установке

Страница: 33 / 104

Installation 5012-33 Installation Manual
3-13
3.9. Setup - Media Xchange Point™ (MXP)
Now that you have installed the hardware, you will need to setup, calibrate and commission the antenna.
You may also need to load/update the modem option file, which is not part of the scope of this manual, contact the
airtime provider NOC for guidance.
At the very least, you will need to set up the antenna system for:
•
Connect & configure a ships computer for accessing the MXP.
•
The gyro compass signal being provided by the ship.
•
Check/Set Home Flag.
•
Set up Blockage zone(s) as needed.
•
Set up / configure all satellites that the system might use as the ship travels, even if there is only one. If your
system will be using iDirect OpenAMIP you will not need to create satellite configurations.
•
Acquire the desired satellite.
•
Optimize targeting (Auto or manual trim).
•
Arrange for commissioning & cross-pol isolation testing with the NOC.
•
Conduct cross-pol isolation testing with the NOC.
•
Conduct other commissioning testing with the NOC (ie P1dB compression point).
•
If this is a Dual Antenna installation configuration, you will have to balance the TX levels of the two antennas
while online with the NOC (refer to procedure in the Dual Antenna Arbitrator manual).
•
It is strongly recommended that you download, and save, the system INI file (contains all of the system
parameters for the ICU and the MXP). Save this file in a convenient location on your computer.