Sea Tel 3011W-91, Руководство по установке

Страница: 42 / 147

Setup – Tracking Receiver - VSAT 3011W-91 Installation Manual
6-1
6. Setup – Tracking Receiver - VSAT
6.1. Determining the IF Tracking Frequency (MHz)
The IF Tracking frequency parameter is a value entered into the ACU’s MHZ Sub-Menu. The value itself may be
provided by your air-time provider and the MHz value will be entered directly in this sub-menu.
Or, the RF downlink frequency of a specific carrier on the desired satellite can be obtained from a satellite website and
calculated by using the formula RF- LO = IF. When you take the Satellite Transponder Downlink RF value and subtract
the LNB’s Local Oscillator (LO) Value, the resultant value will equal the Intermediate Frequency (IF). It is this IF value
that will be entered into the ACU for tracking purposes.
Example assuming an LNB LO value of 11.25GHz: 12268.0 MHz – 11250.0 MHz = 1018.0 MHz IF
Identifying the Downlink RF using SatcoDX
Identifying the Downlink RF using Capture from Lyngsat.com
6.2. KHz
The KHz rate entered into the ACU is an absolute value which also may have been provided by your air-time provider,
or have been calculated, and is entered directly in this sub-menu window.
In the example above, 1018.0 MHz was calculated (1018 MHz 000 KHz) therefore, the KHz entry would be 000. If the
provided/calculated value had been 1018.250, 1018 would have been entered in the MHz window and 250 would be
entered in the KHz window.
6.3. FEC
6.3.1.
The Forward Error Correction rate entered into the ACU should always be set to
SCPC
with an L-Band SCPC
receiver card installed in the ACU.
L-Band SCPC Receiver
6.4. Tone
6.4.1.
In the Series 09 VSAT antenna system, there is no need for below decks band selection and thus there is no
applicable use for tone control. For VSAT antenna systems that have voltage and tone controlled multiband
LNB’s installed, you will use the tracking band selection to control/toggle the tone state of a 22 KHz tone
generator (installed in the above decks equipment). For detailed information, refer to the “SETUP-Band
Select” section of this document.
VSAT Application