FINAL INSTALLATION
1. Insert well light lamp housing assembly into hole allowing
enough loose socket leads for relamping. Run cable
along surface of ground. Tamp ground to secure in place.
2. Attach fixture cable to main supply cable with connector
(#9477) (supplied) or use silicone filled wire nuts (#9386)
(not included).
*CONNECTOR
FIXTURE
CABLE
WELL LIGHT
HOUSING
*GRAVEL
6”
*NOT INCLUDED
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR
INJURY TO PERSONS.
IMPORTANT SAFETY INSTRUCTIONS!
Lighted lamp is HOT!
WARNING: TO REDUCE THE RISK OF FIRE OR INJURY
TO PERSONS:
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when
turning on.
3. Do not touch hot lens, guard, or housing.
4. Keep lamp away from materials that may burn.
5. Do not touch the lamp at any time. Use a soft cloth.
Oil from skin may damage lamp.
6. Do not operate the fixture with a missing or damaged shield.
SAVE THESE INSTRUCTIONS!
INSTALLATION AND SAFETY INSTRUCTIONS
FOR YOUR SAFETY
HC-564
WARNING: Be sure the electricity to the wires you are working
on is shut off; either the fuse removed or the circuit breaker off.
RISK OF FIRE: Exceeding maximum wattage may result in
over-heating conductors. Read instructions carefully. If you are
unclear as to how to proceed, consult a qualified electrician.
NOTE:
The supplied connector works with maximum 12/2 Ambiance
landscape cable. To connect this well light to 10/2 Ambiance
cable, silicone wire nuts (#9386) should be used.
FIXTURE
WIRE
NOTCH
CONTACT
MAX. 50W AT 12V (OUTDOOR)
1. Cut the fixture wire to desired length.
2. Split ends of wire about (1/2") and insert each end of the wire
as far as possible into the plug. Do not strip any insulation off
the wire.
3. Insert contact into one end of plug and press or use pliers until
contact is flush with plug. Repeat with other contact (see Fig. 3)
4. Twist wires sideways, insert into notch in plug and twist back
straight.
5. Snap landscape clip under the low voltage supply cable.
6. Snap plug on to clip and cable.
INSTALLATION OF (9477) CONNECTOR
FIG. 3
SET SCREW
WIRE CLIP
#9477
CONNECTOR
*LOW VOLTAGE
LANDSCAPE CABLE
FIG. 4
WARNING:
TO AVOID EXCESSIVE HEAT AND THE
POSSIBILITY OF DAMAGE TO THE FIXTURE AND
SURROUNDING AREA, MAKE SURE THE HOUSING AND
GLASS LENS ARE NOT BURIED AND FREE FROM
DEBRIS.
FIG. 2
*NOT INCLUDED
FIXTURE
CABLE
#9477
CONNECTOR
FIXTURE CABLE
INSTALLATION
1. Dig hole the diameter of plastic pipe and about six inches
deeper - fill bottom of hole with gravel for drainage.
