120V
2
Install the Remote Transformer
TERMINAL
BLOCK COVER
SMALL SCREW
Loosen (do not remove) the two small screws on the
terminal block cover. Remove the cover.
Loosen the two screws on the terminal block.
Bring properly sized supply wires (min 18AWG) to
transformer.
Connect the hot and neutral 120V power line wires
into the 120V terminal block of the transformer.
Re-tighten the screws on the terminal block.
1A
1C
1
1
3
4
5
6
7
8
Press and hold the “Press” button on the line voltage
side and pull it apart from the low voltage side.
1B
2
HIGH VOLTAGE SIDE
LOW VOLTAGE SIDE
PRESS
TERMINAL BLOCK
Note:
This transformer does not require connection to
a supply ground wire to insure safe operation. It is
manufactured using a polymeric enclosure that
provides complete isolation. If using three conductor
supply wires, please sever the ground conductor
cleanly so it terminates in the transformer wiring
compartment.
LINE VOLTAGE WIRES
(Min 18AWG)
1D
120V
1
LOW
VOLTAGE SIDE
Re-install the terminal block cover and secure it with
the two small screws.
Re-connect the high voltage side to the low voltage
side.
120V
HIGH
VOLTAGE SIDE
SMALL
SCREW
TERMINAL
BLOCK COVER
7
7
4
PRESS
2
PRESS
6
6
