6
Take adapter number 1
from the cluster and firmly
push it into the grey tube
that is already connected
to the end of the hose. To
ensure that the adapter
is on as tight as possible,
push it past the raised
ring that is inside of the
adapter.
BTP Turbo Pump
Connect the other end
of the hose to the red
inflation port at the top
of the pump, located near
the ON and OFF buttons.
PSI numbers are red.
BP12 Electric Pump
Connect the hose to
the red inflation port in
the end of the pump.
PSI numbers are
yellow.
Adjust the pressure dial
to read 3.2 PSI which is
the operating pressure
of your Sea Eagle. PSI
is marked in red on the
dial. Never turn the
dial when the device is
under pressure as this
will immediately cause
the instrument to break.
Connect the cord at the
end of the power supply
into the end of the cord
attached to the pump.
Connect the Turbo Pump
to a 12V battery (car or
marine) using the
alligator clips at the end
of the extension cord.
Connect the red clip to
the positive pole and the
black clip to the negative
pole.
Press the ON button to
begin inflation. The pump
operates in two stages
which can be identified by
the noise of the turbine at
the start, followed by the
piston. The pump
automatically stops once
the pressure is reached.
Warning:
Air compressors that
are designed for other
uses like tire inflation
(usually around 50 PSI)
can easily harm your Sea
Eagle which works at a
much lower pressure of
3.2 PSI. For this reason
we recommend only
using Sea Eagle pumps.
INFLATION, VALVES & PUMPS
