14
FastCat14.4 | ASSEMBLY & INFLATION
Layout canvas upside
down (shiny side up).
Slide one curved bar into
the canvas sleeve with
locking holes up.
Slide the second bar into
the other sleeve with
locking holes facing down.
Canopy (OPTIONAL)
Canopy kit includes two
curved bars, two side rods,
canvas, two black knobs
and two short (35mm)
screws. Additional
hardware may be included
that is not for use on the
FastCat14.4.
Fold the canvas in half so
the shiny side is facing out
and the bars are lying on
top of each other.
Insert the side rods into the
curved bars until the
locking pins engage
through the holes.
Place the canopy on the
back of the boat. Arrange
the bars so the long bar is
on top and the short bar
underneath.
When raised, the short bar
will be towards the back of
the boat.
Attach the rear clips to the
small D-rings behind
transom. Attach front straps
behind the front carry
handles. Adjust and tighten
straps by sliding the
buckles.
Canopy should be level and
not flap in the wind. Adjust
straps until canopy is level
and tight.
Use the M6 x 35mm (1 3/8”)
screw and the knob to
secure the rods to the black
canopy pads on the boat.
Run and 8’ strap between
the D-rings. Place cooler
over the strap. Run strap
through handle or slot and
back under the cooler. Run
strap through handle or
slot and tighten.
Caution:
Do not
overtighten strap, and do
not overload cooler or box.
If handles break, box could
be lost overboard.