For battery charging follow these instructions.
1. Always ensure that the Safety Lock in the Off position is
Off - see fig. 5b.
2.
Always ensure that the SEA-DOO
®
SEASCOOTER
™
Dolphin / Aqua Ranger is out of the water, dry and placed
in a dry area.
15. Replace the Nose Cone and close the latches.
3.
Pull the latches down and remove the Nose Cone as
shown in fig. 6.
4. Allow two minutes for any gasses to dissipate.
5.
Disconnect the battery cable from the housing cable
(if not already disconnected - the cable will be
disconnected when you buy your SEASCOOTER
™
) by
pressing the locking feature, as shown in fig. 7.
6. Remove battery and place on a level surface.
7. Connect the battery cable to the charger cable.
8. Plug charger into mains, and turn on the supply.
9. Charging will take 14-16 hours for a fully discharged
battery. When the battery is charging the red LED is lit,
when the battery is charged the green LED is lit.
10. Disconnect the Charger from the mains.
11. Unplug the battery cable from the charger cable.
12. Allow battery to stand for 30 minutes before using it.
13.
When ready for use, place the battery into the housing
and connect the housing cable.
14. Make sure the seal and sealing surfaces are clean and
lubricated before replacing the Nose Cone. See fig. 8.
Care And Maintenance
Battery and Catalyzer Care
Please read and understand important Battery Use safety
information on page 11, 12, 13 and 14.
• The battery supplied with your SEA-DOO
®
SEASCOOTER
™
should last about 200 cycles or two
years before it should be replaced. Please contact your
local customer service centre/distributor. Using a battery
in excess of these recommendations can result in
excessive off-gassing of explosive gases.
• A safety catalyzer, to protect against explosive gas in
normal use, is held in a spring in the bottom of the
battery housing and should be replaced at the same time
as any battery replacement (Fig. 10). The catalyzer
should be replaced sooner if it appears to be damaged.
Please contact your local customer service
centre/distributor.
• If the catalyzer is wet, it will not function and must be
allowed to dry out before use.
19
18
Care after using the SEASCOOTER
™
ALWAYS remove the battery from the
SEA-DOO
®
SEASCOOTER
™
immediately after use.
DO NOT STORE BATTERY IN SEASCOOTER.
• Always rinse the SEASCOOTER
™
in fresh water and
allow it to dry before storage immediately after use.
• Whenever possible rinse the SEASCOOTER
™
in fresh
water immediately after use.
• To clean the SEASCOOTER
™
do not use detergents,
only use a damp cloth to wipe the unit clean.
• The Battery Housing interior should be kept dry at all
times.
• If the Battery Housing interior ever gets wet, see page
23, Accidental Flooding for steps to take.
• When storing the SEASCOOTER
™
for extended periods
of time, open and remove the Nose Cone.
• ALWAYS store your SEASCOOTER
™
vertically when not
in use to prevent deformation of the Propeller Nozzle.
Catalyzer
Fig.10
