E-10
Flash OPEN switch
Part A
Anti-reflective tape
Mode dial
lock release button
Mounting the Camera in the Housing
Before installing the camera, slide the
Flash OPEN switch to the outside to
raise the flash cover, open the flash,
and remove the lens cap from the
camera. Turn off the power of the
camera before installation.
To avoid flooding by trapping,
remove the hand strap from camera
before installation.
Please take precautions to make
sure that the camera is not inserted
at an angle. If you attempt to forcibly
insert the camera at an angle, the
lock button of the camera may become
caught on the housing and cause
the camera to become damaged or
to malfunction.
Place the anti-reflective tape on
the lens nameplate (part A) on
the camera
CAUTION
1
Turn off the power of the camera
and place it as shown in Fig.3
2
CAUTION
Fig.1
Fig.2
Fig.3
Fig.4