SE Munro Egg 150, Руководство по эксплуатации

Страница: 10 / 12

BEFORE USING YOUR EGG 150 SYSTEM PLEASE READ THESE NOTES CAREFULLY
Important safety Information
This unit contains high voltages and hot components and must not be opened in any circumstances.
The Egg 150 is a complete stereo system and the control unit, speakers and interconnecting cables are unique.
No substitutions of any sort should be used and no other speaker or amplifier can be used with the cables.
The IEC (or US Equivalent) three core mains cable must be used with appropriate regard for earthing and supply voltage.
Do not use any other type of cable.
There are no user serviceable components inside the control unit and it is hazardous to open or operate the system with the unit open.
Internal fuses exist to protect the Egg components and in the event of system failure or inoperation please report the fault to
sE Munro or their representative for further advice.
The control unit requires adequate ventilation and the top panel must not be covered or placed near a source of heat or moisture.
Do not disconnect the speaker cables when the system is switched on.
Set Volume controls to minimum before connecting/disconnecting inputs
WARNING
Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, short
circuiting, damages, fire or other hazards. These precautions include the following:
!
The power supply (if included with this system) contains no user-serviceable parts. Do not attempt to disassemble or
modify the internal components of the power supply in any way.
!
Do not expose the system to rain, use it near water or in damp or wet conditions.
!
If the power cord or plug becomes frayed, damaged, there is a sudden loss of sound during the use of the system or any
unusual smells or smoke should appear to be caused by it, turn the power switch off immediately, disconnect the mains
plug from the wall and have your system inspected by a qualified technician.
!
Only use the voltage as specified as correct for the system supply.
!
Always attach the three-pin attachment plug for the power supply to a properly grounded power source.
!
Check the mains plug periodically and remove any dirt or dust that may have accumulated on it.
!
Do not place the power cord near heat sources such as heaters or radiators and do not excessively bend or otherwise
damage the power cord, place heavy objects on it or place it in a position where anyone could walk or trip over, or roll any
thing over.
!
When removing the power cable from either the power supply or the wall outlet, please do not jerk or pull on the power
cord. Always remove the cord by holding the plug itself.
!
Always connect the power supply to a direct outlet and not an extension cord. Doing so may result in an inadequate power
supply for the unit to operate at specified levels.
!
Always remove the plug from the outlet when the power supply is not in use for extended periods of time (longer than two
weeks). Also remove the plug from the outlet during any electrical storm.
!
Do not expose the system or power supply to any excessive dust or vibrations or extreme cold or heat.
This includes but is not limited to: a car on a hot day, direct sunlight for long periods of time or near a heater or a radiator.
!
Our power supplies are made for international use, so they all come with a voltage switch. This switch can be located on
the back of the unit next to the on/off switch. You will have a selection between115v or 230v. Please make absolutely sure
that you have the correct voltage selected for your outlet as a mistake in selection could cause serious damage to the power
supply and/or the system that is connected.
! sE Munro
cannot be held responsible for any damage caused by improper use or modifications of the system or power supply.
SAFETY NOTICE
The Egg 150 System
Operation Manual
7