Installation Instructions for the
T-Series Alarm Systems w/Power
Se-Kure Controls,
®
Inc.
3714 Runge Street • Franklin Park, IL 60131 • 1-(800) 322-2435 • (847) 288-1111 • Fax: (847) 288-9999
Rev.
11
/
12
/09
SCI-9936
©2009 Se-Kure Controls,
®
Inc.
Other Models Available
SK-T6P
T6 Alarm with
Power
SK-T12P
T12 Alarm
with Power
SK-295P
12 Volt Power Supply
Provides Power to the T-Series
Alarm & 5v to Connected
Devices
Sold Individually
Available on
SK-T6P-R & SK-T12P-R
Remote Keyway
Available on
SK-T6PK & SK-T12PK
T-Series w/Power & Keypad
Available on
SK-T6XP & SK-T12XP
Remote Horn
SK-110
Double Bit Keys
(6) “AA” Alkaline Batteries
(Not Included)
On the Web: www.se-kure.com
E-Mail: [email protected]
Battery Installation:
1.
Remove the screw at the upper
right that holds the cover closed,
and unlock the cover with the key.
Special Note:
Remote key units
only need to have the tamper screw removed.
2.
Open the cover and install (6)
new “AA” Alkaline batteries, (3) on
each holder following the polarity
indicated on the battery holders.
3.
Close the cover, lock the box,
and replace the screw that holds the cover.
Special Note:
The AC/DC Power Supply is the pri-
mary power source and provides power to the
devices on the display.
If power is cut off:
the
alarm transfers to battery operation. Devices on the
display will lose power, but the alarm remains active
and will )))
sound
((( in an Alarm Condition if the bat-
teries are good.
(Optional)
Remote Key
Installation:
1.
Determine the location on the display where
the remote key will be positioned.
IMPORTANT: (IN DETERMINING THE LOCATION
)
The Remote Key Switch
cable must be able to
reach
from the
Alarm Module
to the
Remote
Location
.
2.
The Key Cylinder fits
through a 3/4” hole
in the display surface,
and has a hex nut to
tighten it to the display
surface.
3.
Plug the other end of remote key
switch into a T-Series Alarm
Module that has been equipped
with a remote key jack.
3/4" Hole
Hex Nut
Display
Factory Installed Optional Items
