Installation Instructions for the
Fire Extinguisher Alarm
SP-101
SP-101
Fire Extinguisher Alarm System w/Key, Sensor, Adhesive & Strap
SP-103
Special Beaded Strap
SP-102
Alarm Sensor
SP-909NP
Sensor Adhesive with
Neoprene
SP-1483
Extra Key
SP-1909
(2) 1" x 2" Adhesives
w/ Alcohol Prep Pads
Battery
Connector
Sensor Port
9-volt Alkaline
Battery
(Not Supplied)
Cover
Plate
(4) Phillips Head (Cover Plate) Screws
Battery Installation:
1.
Remove the (4) phillips head
screws to open the battery
compartment as shown in the
diagram below.
2.
Insert the key, push in and
turn clockwise.
(This places the Alarm in the
“Stand-by” position).
Note: The key can only be
removed in the “ON” position.
3.
Attach a 9-volt alkaline battery
(Not Supplied) to the
connector, and insert the
battery into the compartment.
4.
Replace the cover plate and
the (4) phillips head screws.
(Note: Tighten screw until it
stops–
Do Not Over-Tighten
).
