MAN.200.EN--05--SDT200-user-manual-Eng.docx
7/19
Turning on & turning off the SDT200
To turn on:
Press the
Power button
on the bottom right of
the keypad. The status LED will shine dark blue.
Then, a few seconds later you will see on the
screen the SDT logo and the message “loading”. If
you do not see this display your battery might be
flat.
To turn off:
Push the
Power button
on the bottom right of
the keypad. You will see the following display:
Confirm the device shut down by pressing the
Enter button
.
Plug & unplug an external sensor
The SDT200 is equipped with a LEMO
connector, used to plug external sensors.
It is a commonly used industrial connector,
considered for its reliability and robustness. It
have a sprung-loaded knurled barrel and
mechanical polarisation to go only in one way
round.
To plug a LEMO connector:
Line up the red dot on the plug with the red mark on the connector.
Insert the plug into the connector without any rotating movement.
When an external sensor is connected to the SDT200, it is automatically selected. Howerver, you
can switch between available sensors using the
F1 button
.
To unplug the LEMO connector
Move up, towards the cable, the ring located on the bottom of the plug.
Only pull the connector without any rotation.
Please, never pull on the cable itself.
