BUILDPLATE PRO WITH FLEX-FUNCTION
HOW TO INSTALL AND TAKE CARE OF YOUR NEW BUILDPLATE:
Place your new BuildPlate on the Printer’s Base. Check that the Buildplate can rotate 360 de-
grees when you attach it to the printer.
Product 45030005
2
After printing is done, it’s time to remove the print from the BUILDTAK. Start by removing the
entire BuildPlate from the printer’s base.
INSTALLATION:
MAINTENANCE:
The surface of your BuildPlate –the BUILDTAK– should be cleaned before every print with an
Isopropyl Alcohol and a cloth. It prevents your prints from falling off the buildplate during printing.
USAGE:
1
A)
B)
C)
Adjust the nozzle height by ‘calibration of Z-axis’ OR turning the threaded rod manually while
first layer is being printed. Like this:
Start printing. Every time you start to print, check how the first layer of your print looks like:
Picture A: It’s all good - the nozzle squeezes the filament onto the Buildplate in fine coherent
layers and the filament can flow freely.
Picture B: The nozzle is too close to the Buildplate and the filament cannot go through the nozzle.
Picture C: The nozzle is too far away from the Buildplate. The print will fall off during printing.
