15
Caution:
1. Transmitter/receiver boot time require 30 seconds
2. Transmitter must be reboot to apply channel setting by hardware rotating switch
3. Not recommend to work with existing LAN connection to avoid large video, data transmission or
multicast packets to slow down your other LAN devices.
4. Gigabit switching hub muse support IGMP and Jumbo Frame over 8K in order to achieve the
best quality
5. If monitor shows green screen, please check if the switch running under gigabit and
IGMP/Jumbo Frame function enabled.
6. If video not smooth please check if IGMP function enabled or bandwidth of switch closes to
maximum.
7. When using computer or mobile APP management the IP address should be set in same
network segment.
8. Computer software and APP operation please refer to software operating instruction.
9. If receiver switch to transmitter which no video input, it will show blank screen or last still image
for a while.
10. Fast switch mode might cause screen or audio abnormal briefly when switch channel.
11. In high resolution (like 1080p) the OSD response will be delayed a little bit.
12. If IR remote not work properly, please check the battery (especial in low temperature) and
reset IR ID.
13. Audio in of HKM01BR, VDKM01BR is designed for Mic in, not for Line in
14. Screen saver function not support monitors which only works based on HDMI +5V signal.
15. If any video resolution issue please try to rest EDID of TX by web or use MENU 300 to copy
EDID from the monitor of RX