TB-9048
Page 2 of 3
© 2016 DESCO INDUSTRIES, INC.
Employee Owned
SCS
- 926 JR Industrial Drive, Sanford, NC 27332 • (919) 718-0000 • Website:
5.
Press and hold the OPERATOR LEFT button on the
Verification Tester. The OPERATOR LED on the
WSMONITOR2 should illuminate green. Release
the button. The LED should flash red, and the
audible alarm should sound briefly.
6.
Press and hold the BENCH button on the
Verification Tester. The BENCH LED on the
WSMONITOR2 should flash red, and the audible
alarm should sound. Release the button. The LED
should illuminate green red, and the audible alarm
should not sound.
7. The monitor is within specifications if it responds as
described in steps 5 and 6.
WSMONITOR3
1.
Ground the TMTOOL Verification Tester by
connecting its GROUND lead to eletrical ground.
2.
Power the WSMONITOR3 monitor.
3. Insert the OPERATOR LEFT lead from the
Verification Tester into the operator jack located on
the left remote of the WSMONITOR3 monitor.
4. Insert the OPERATOR RIGHT lead from the
Verification Tester into the operator jack located on
the right remote of the WSMONITOR3 monitor.
5. Insert the BENCH lead from the Verification Tester
into the BENCH SYSTEM GROUND jack located on
the back of the WSMONITOR3 monitor.
6.
Press and hold the OPERATOR LEFT button on
the Verification Tester. The LEFT OPERATOR
LED on the WSMONITOR3 should illuminate green.
Release the button. The LED should flash red, and
the audible alarm should sound briefly.
7.
Press and hold the OPERATOR RIGHT button on
the Verification Tester. The RIGHT OPERATOR
LED on the WSMONITOR3 should illuminate green.
Release the button. The LED should flash red, and
the audible alarm should sound briefly.
8. Press and hold the BENCH button on the
Verification Tester. The BENCH SYSTEM
GROUND LED on the WSMONITOR3 should flash
red, and the audible alarm should sound. Release
the button. The LED should illuminate green red,
and the audible alarm should not sound.
9. The monitor is within specifications if it responds as
described in steps 6-8.
Figure 4. Connecting the Verification Tester to the
WSMONITOR3 monitor
BACK
FRONT
Figure 3. Connecting the Verification Tester to the
WSMONITOR2 monitor
FRONT
BACK