TB-9031
Page 4 of 4
© 2015 DESCO INDUSTRIES, INC.
Employee Owned
SCS
- 926 JR Industrial Drive, Sanford, NC 27332 • (919) 718-0000 • Website:
StaticControl.com
Procedure
• Connect 3.5 mm test cable to both the Workstation
Monitor Checker CTE701A and to the Operator jack of
your monitor.
• Press and keep pressed the “Wrist strap” button.
Your monitor LED will turn from red to green and your
audible-alarm will turn off.
• While keeping Pass button, press and keep pressed
Body Voltage “High” button.
• Your monitor should provide indication of excessive
body voltage in each polarity – positive and negative.
When Body Voltage Low button is pressed, no Body
Voltage indication should be present in the monitor.
Regulatory Information
e-Waste Disposal-Recycle according to applicable local,
state and federal laws for electrical/electronic waste.
WEEE Statement
The following information is only for EU-member States:
The mark shown to the right is in compliance with Waste
Electrical and Electronic Equipment Directive 2002/96/
EC (WEEE). The mark indicates the requirement NOT to
dispose the equipment as unsorted municipal waste, but
use the return and collection systems according to local
law.
ICES Statement
This Class A digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe A est conforme à la
NMB-003 du Canada.
FCC
Note: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide a reasonable protection against
harmful interference when the equipment is operated in
a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference
in which case the user will be required to correct the
interference at their own expense.
Note: Modifications to this device shall not be made
without the written consent of SCS. Unauthorized
modifications may void the authority granted under
Federal Communication Rules and Industry Canada
Rules permitting the operation of this device.
CE Statement
Meets CE (European Confomity) requirements.
Battery Disposal
Dispose of batteries in accordance with state and local
requirements.
Limited Warranty, Warranty Exclusions, Limit of
Liability and RMA Request Instructions
See the SCS Warranty -
http://staticcontrol.descoindustries.com/warranty.aspx