FIXA
TION ET CONNEXION DES
Attaching
1) Attach the exterior camera at a height of 1.5 metres mounted on a flat wall.
2) First fit the rear support. Finish by tightening the screw at the bottom of the panel.
3) Connect the camera wire (as shown in the diagram below) and insert the camera onto
its support. Do not set up the camera where it is in direct contact with the rain or sun.
After installing and testing, place a clear silicon seal on the top and sides of the exterior
camera (not on the bottom) to avoid any risk of infiltration.
4) Attach the rear support of the monitor (at a height of 1.5 metres on a flat wall).
5) Connect the wires and insert the monitor onto its support.
WIRE SECTION :
Monitor-camera link
Monitor - automatic opener or lock link
From 0 to 15 metres: use the cable provided.
Extend it if necessary by a maximum of 50
metres with 0.75mm² cable.
From 0 to 10 metres: use RVV2 *1mm²
cable.
CABLING DIAGRAM :
ATTACHING AND CONNECTING THE ELEMENTS
3
CAMERA M2
SERRURE OU
GÂCHE
EN OPTION
ADAPTATEUR
18 VOLTS
MONITEUR V5
1
2
3
4
-
+
1
2
3
4
5
6
ENGLISH
MONITOR
CAMERA
BLACK
12V700mA
RED
1.5 m
1
2
3
4
5
1
2
2
1
MONITOR
Camera
red
black
+
-
Transformer
MONITOR
Ringing volume setting