TB-9023
Page 11 of 16
© 2017 DESCO INDUSTRIES, INC.
Employee Owned
Memory Storage Card
The EM Eye Meter works with microSD Cards.
At the HARDWARE SETUP menu, press the triangle
(MODE OPTION) button located at the upper right side
of the display.
The MODES OPTION screen is used to enable or
disable any of the functions modes:
1) EM field; 2) Power Density; and 3) EIRP.
You can always enable previously disabled modes.
Use the navigation bar as follows:
UP/DOWN scrolls the cursor field through the three
modes.
LEFT/RIGHT enables or disables the selected mode.
“V” – enabled; “X” – disabled
Figure 28. Interval and Average setup menu
Figure 29. Hardware setup menu
Figure 30. Using the hardware setup functions
Figure 27. MicroSD card example
Some cards may not be compatible.
Non-compatibility is indicated by an “X” mark
overlaid on the card button display. For other
memory card types, please contact SCS
Customer Service for verification.
Electromagnetic Field Sensor,
Power Density Meter and Effective
Isotropically Radiated Power (EIRP)
Meter Display and Controls
Menu Function
When the MENU F button is pressed momentarily, the
INTERVAL and AVERAGE data recording timing can be
configured.
INTERVAL, in seconds, is the sampling time for PEAK
data to be recorded onto the microSD storage card.
AVERAGE, in seconds, is the sampling time for
AVERAGE data to be recorded onto the microSD
storage card.
When the MENU F button is pressed for a longer period,
the hardware setup is shown. At this point, brightness,
off-time and antenna factor can be adjusted.
Relative Antenna Factor (AF)
-40 dBm-1 to 40 dBm-1
Default relative antenna factor for the supplied local
antenna is 0.
EMF Units Conversion
Pressing the UNITS button toggles between dBμV/m
and V/m unit.
Power Density Units
The UNIT button is not a touch feature.
The unit of power density is W/cm2.
www.
.com
1.800.561.8187
