SCROOSER GmbH
All rights reserved.
22
For security reasons the rear-view mirror is demounted during transport and enclosed.
How to mount and adjust the rear-view mirror:
1.
Screw the bolt with the blue colored thread in the lower part of the mirror and tighten with an
Allen wrench. Thread black nut onto the bolt.
2.
Mount and screw the mirror onto the clamp attached to the handlebar.
3.
With a wrench tighten the black counter nut to adjust the mirror arm.
4.
Use ball joint to adjust the mirror according to your desired driving position.
How to adjust the handlebars:
1.
Loosen the four screws on the handlebar clamp and adjust the handlebars as required.
2.
After adjusting the handlebars, carefully tighten the four screws again. To achieve the
required clamp tension between the handlebars and the handlebar clamp, the screws
must be tightened to a torque of 15 Nm.
Caution: failure to tighten screws to the specified torque can result in damage to the handlebar
components (risk of accidents!).
How to check that the brakes are working:
1.
Engage the front and rear brakes, and check that both the front and rear brake lights light up
when you do so.
2.
If the brakes do not work at all or are defective, contact a specialist (see “Service partners”).
Mounting and adjusting the rear-view mirror
Adjusting the handlebars
Checking the brakes
