To finish, pull the Cable tie loop to the outer
edge and not through the large center hole
see
Top image
, connect and trim the ends of the
Cable Ties as needed.
Insert two
Cable Ties
through the Small
Holes that are
opposite each
other on the Legs
of the “X”, repeat
for the second “X”.
(Note: The correct
way to connect the
Cable Tie
(See Below)
4
How to connect the Cable Tie Loop
Insert on the flat side
Create the “Stand
-
Off Tube Ends” by peeling
back the slit ends of the Stand-Off Tube (like
peeling a banana)
5
6
Position one “X” onto
the Stand-Off Tube and
align the four “X” Legs
with each of the four
“peeled back” Stand
-Off
Tube Ends.
Attach all 4 Legs to the Stand-Off
Tube Ends with Cable Ties. Apply
the tie close to the center post,
capturing a knob, which prevents
the tie sliding outward. (Trim
excess Cable Tie after tightening).
Note:
Make sure the Short Tube
has been removed in Step 4.
7
Repeat Steps 6 and 7 to attach the second “X”
Assembly on opposite end of the Stand-Off
Tube..
8
2
Once tied tight, discard the Short Tube from the
“X”
Repeat Steps 1-
4 to assemble the other 2 “X”
Knobs
