12
RECHARGING THE BATTERY
The module is delivered with the battery partially charged:
it is therefore necessary to put it through at least one
complete charge cycle.
When supplied with a solar panel (optional): during the
normal operating cycle, the solar panel helps keep the
battery module charged. In certain cases, e.g. solar
panel positioned on the north side of the building or in a
shady area, intense use, or very low temperatures, it may
nonetheless be necessary to recharge the battery also by
means of the charger SL2405, if provided.
If the battery needs recharging, the arrows will flash
red following an up or down command. Recharging is
automatically controlled by the battery module.
To recharge the battery:
1. Detach the battery module from the base plate;
2. Plug the battery charger into a power socket;
3. Plug the micro-USB connector into the port provided on
the module.
When the charger is connected, the LED will indicate the
following conditions:
• LED blinking: charging underway
• LED steadily lit: charging completed
After charging, detach the cable and fit the module back
onto its base plate.
In case of a new battery, 2-3 full charging/discharging
cycles may be necessary to bring the battery to its full
capacity.
MEMORIZING RADIO CHANNELS AND OPERATING MODE
The information relating to the radio channels and the
operating mode of the blind is saved on a memory card
housed in the battery module base plate (namely, the fixed
part applied on the glass or the window frame, which is
connected to the blind).
N.B.: if several blinds and several battery modules are
installed, it is not necessary to always reposition each
battery module onto its corresponding base plate, since
the remote controls and channels are associated with