Dahl Docking Manual Scout Mobility
7 of 12
4101976 Revision A Sept. 2018
4. Now take the Dahl spacer (Dahl part no: 500673, docking plate (Dahl part no: 500561 and 5
special Dahl high grade steel (14.9) Torx bolts (Dahl part no: 502800) to mount the Dahl docking
plate on to the bottom side of the X10 chassis.
NOTE
The special Dahl high grade Torx bolts (Dahl part no: 502800) only come in one length which is
often too long. They need to be cut into the right length by the authorized engineer to fit the
locking plate properly without damaging the batteries.
5. After cutting the bolts to the right length, Loctite 222 needs to be added onto the thread to secure
the bolts.
6. The five Torx bolts (T27 key) shall be tightened with a torque wrench to the preset torque of 16-18
Nm.
7. Place the batteries back into the chassis and re-connect them to the electronics.
Note : Only use the 8 mm Dahl Spacer between locking plate and wheelchair battery box. This
ensures sufficient (60 mm) of ground clearance under the wheelchair for safe daily use. See
picture below.
Now the X10 wheelchair is ready to be docked into the Dahl Docking station. The mounting of the
Dahl Docking station into your vehicle shall only be executed by an authorized car adaptation
company. They will get the right support and information from Dahl Engineering on how to mount
the docking station into the designated vehicle.
WARNING
The Dahl Docking station is only allowed to build in to a vehicle by trained and authorized staff
of a registered car adaptation company. For ordering the Dahl Docking and its accessories,
please contact Dahl Engineering in Denmark for further details. You can find Dahl at
www.dahlengineering.dk