Scout Mobility BV
Page 4 of 17
rev-2018-01
1. Setting up and using the wheelchair
1.1 Using the Locking Bar
The Locking Bar provides a possibility to unlock the rear castor position and climb small obstacles and
ramps with the Warrior. When the rear castors are unlocked the maximum speed of the wheelchair
is automatically reduced for safety reasons. It is advised not to use Match drive Profiles when the
Locking Bar is unlocked.
To unlock :
•
Pull the Plunger Bolt (1)
•
Lift the Locking Bar (2) and release
the Plunger Bolt.
To lock :
•
Push the Locking bar down until you
hear the Plunger Bolt Click
1.2 Adjusting rear castors
•
For safe and optimal use of the
Warrior wheelchair, the rear castors
need to be correctly adjusted to
ensure stability of the wheelchair
during use.
•
Set the tire pressure of the drive
wheels to 2.5 bar
•
Have the user sit in the chair
•
Lock the rear frame by pushing the
locking lever down until you hear
the securing pin click (see § 1.1)
•
Loosen the upper M20 nut (1) on
the rear castor axles.
•
Adjust the lower M20 (2) nut until
the rear castor firmly touches the
floor.
•
Retighten the upper nuts (approx.
25 – 30 Nm)
Note :
Wear on the drive wheel tires, tire pressure and user weight can influence the correct height position
of the rear castors. It is important that the correct adjustment of the rear castors is checked before
every use of the chair.
