Page 13
Sea-Hub Advanced User Manual
Scout
-
WAN Connection
- Select
Single WAN (ADSL only)
for the WAN port connection from the drop-down list.
-
Enable MAC Clone
- Some ISPs limit Internet connections to a specified MAC address. This setting allows you to manually change
the MAC address of the Sea-Hub’s WAN interface to match the PC’s MAC address provided to your ISP for registration. You can
enter the registered MAC address manually by typing it in the boxes provided. Otherwise, connect only the PC with the registered
MAC address to the Sea-Hub, then click the Clone your PC’s MAC Address (default: Disable).
-
User Name
- Sets the PPPoE user name for the WAN port (default: pppoe_user; Range: 1~32 characters).
-
Password
- Sets a PPPoE password for the WAN port (default: pppoe_password; Range: 1~32 characters).
-
Verify Password
- Prompts you to re-enter your chosen password.
-
Operation Mode
- Enables and configures the keep alive time and configures the on-demand idle time.
Note
: If static IP is required for your DSL modem then you need to click Advanced tag followed by WAN to bring up Static IP
Configuration
You may enable 3G USB as backup WAN connection when DSL is not functioning.
Mode: Dual WAN (ADSL + 3G)
Please refer to Connection type: 3G dongle for setup detail on 3G modem.
Note
: you may reverse the primary & backup WAN connection by click Advanced tag followed by WAN (see screen below).
