10
PLASMA 4
| BIKE OWNER’S MANUAL 2015
BIKE OWNER’S MANUAL 2015 |
PLASMA 4
11
E
N
G
LI
S
H
E
N
G
LI
S
H
SEATPOST ASSEMBLY:
IMPORTANT
Before assembling the seatpost into the frame, make sure the rear side of the
seatpost (side where head is longer) is at the rear end of the frame
1. push gently the seatpost into the frame
2.
for electronic shifting:
make sure the battery does not get stuck into the frame
3. once the desired seatpost height is achieved pre-assemble the seatpost wedge:
position the upper wedge part (505) over the mid wedge part (504) and the low
wedge threaded part (503) below the mid wedge part
4. position the M6 wedge screw (506) into the assembly head up and pre-tighten it
over 3 turns
5. position the wedge assembly into the seattube insert in front of the seattube, its
concave face should correspond to the seatpost front surface
6. tighten the M6 screw to the specified torque (T11) while making sure the upper
surface of the wedge coincides with the upper surface of the top tube.
Seatpost and seatclamp assembly are fully compatible between Plasma 4 and
Plasma 5 frames.
-
Seatpost Plasma 4/5 SCOTT part number: 239318
-
Seat Clamp Plasma 4/5 SCOTT part number: 239544
STORAGE BOX
Plasma 4 framesets and complete bikes are delivered with an additional storage box
that can be fitted to the top front end of the Toptube via 2 M5 Allen screws as shown
on the sketch below.
