06
KIDS
| BIKE OWNER’S MANUAL 2015
BIKE OWNER’S MANUAL 2015 |
KIDS
07
A
C
B
D
1 mm
1 mm
1
2
1
1
2
2
B C
B + C = 2 mm
E
N
G
LI
S
H
E
N
G
LI
S
H
ASSEMBLY OF TRAINING WHEELS
Assembly of training wheels (only 12” and 16” models) and adjustment of chain
tension on bikes without rear derailleurs For the assembly of the optional training
wheels for 12” and 16” bikes please follow these instructions:
CHAIN TENSION
If the chain needs to be tensioned again, release nut A on both sides and pull the rear
wheel straight backward until the tension is ok
Retighten nut A on both sides Please note the tightening torque in the Tightening
Torques table at the end of this manual
BRAKES
Your new bike is equipped with two brakes which work independently of each other
If you can pull the brakelever more than half of its way to the handlebar, you should
readjust the brake To do so, please follow these steps:
5mm allen key
tightening torque :
6‑8 Nm (52‑69 in lbs )
inner cable lead
Spring tension
adjustment screw
Spring tension
adjustment screw
Depress lever
about 10 times
1 On one side of the rear wheel release nut
A and remove it including the washer
2 Put part B in part C and fix it with nut
A with the washer between nut A
and part C
3 Assemble the bolt and nuts/washers to
fix the wheel on part B as shown
4 The long sleeved hole D will help you to
balance the bike while you assemble the
bike parts on the the other side using the
instructions mentioned above
5 Both training wheels should have a
distance of 1–1 5cm to the ground when
the bike is balanced on its wheels After
balancing the bike please tighten the
wheel fixing nuts and the counter nuts
V‑BRAKE
1 While holding the shoe against the rim,
tighten the shoe fixing nut
2 Pass the inner cable through the inner
cable lead, and after setting so that the
total of the clearances between the left
and right shoes and the rim is 2 mm
tighten the cable fixing bolt
3 Adjust the distance with the spring
tension adjustment screws
4 Depress lever about 10 times
