ENGLISH
67 |
ROAD BIKE |
OWNER’S MANUAL 2021
e
f
d
WARNING
Do a test ride in a place free of traffic, after adjusting the gears of your bicycle.
SAFETY INSTRUCTIONS
Some front and rear derailleurs have very specific set-up instructions. Con-
sult your authorized SCOTT dealer or read the manual of the component
manufacturer.
Shimano Di2
Adjustment and maintenance
If you wish, your SCOTT dealer can also change the functioning of the Di2
control buttons
(e)
. The change has to be done with a special test device from
Shimano which is also used for troubleshooting.
If you have smaller hands and want to position the levers closer to the han-
dlebars, there are special adjusting screws on the handlebars. The handling
of these screws is described in the chapter “Brake lever reach adjustment on
SCOTT road bikes and SCOTT cyclo-cross bikes”.
To adjust the rear derailleur shift into one of the middle gears. Press the button
at the front switch under the handlebars until the control lamp illuminates red
(f)
. The fine adjustment of the rear derailleur can now be carried out. Turn the
crank and listen to the noise of the chain while running.
If there is a noise when the chain rolls off, press the front lever. With every push
the rear derailleur moves inward by one decimillimetre. If the noise gets louder,
press the rear lever.
The rear derailleur moves outwards in steps of one decimillimetre. Once the
chain runs quietly, press the button at the switch once again, the red light goes
out. Finish by shifting through all the gears to check the proper functioning.
Carefully shift through the gears until the chain runs on the biggest sprocket. If
the shifting is not smooth, readjust once again.
