Page 3 of 32
P/N 89332-01 Rev F 7/11
WARNING
RESPIRATORS SHALL NOT BE WORN WHEN
CONDITIONS PREVENT A GOOD FACE SEAL.
SUCH CONDITIONS MAY INCLUDE, BUT ARE
NOT LIMITED TO, GROWTH OF BEARDS,
SIDEBURNS, A SKULL CAP THAT PROJECTS
UNDER THE FACEPIECE OR TEMPLE PIECES
ON EYEGLASSES. ALSO, ABSENCE OF ONE
OR BOTH DENTURES CAN SERIOUSLY
AFFECT THE FIT OF A FACEPIECE. ANY
CONDITION WHICH PREVENTS A GOOD
FACE SEAL MAY PERMIT EXPOSURE TO
THE HAZARDOUS ATMOSPHERE WHICH MAY
RESULT IN SERIOUS INJURY OR DEATH.
WARNING
DO NOT USE THE BLACK POLYESTER
HEAD HARNESS OR NYLON BACKFRAME
HARNESS WHEN ACCIDENTAL EXPOSURE
TO HIGH HEAT OR FLAME IS A POSSIBILITY.
I N T H O S E C I R C U M S TA N C E S , T H E
POLYESTER OR NYLON MAY MELT OR BURN
CAUSING INJURY OR MAY INTERFERE WITH
RESPIRATORY PROTECTION RESULTING IN
SERIOUS INJURY OR DEATH.
The facepiece utilized on this respirator is available in a variety of
sizes and configurations for standard use or special applications. The
facepiece may be readily detached from the breathing regulator to
allow for utilization of the best fitting and most comfortable size face-
piece for an individual user. Fit testing per OSHA Standard 29 CFR
Part 1910 or ANSI Standard Z88.2 requires testing in the negative
pressure mode using equipment such as a Portacount Plus
2
Respira-
tor Fit Tester. For this, SCOTT facepieces require use of SCOTT Fit
Test Adapter P/N 804057-01 or equivalent and appropriate negative
pressure testing equipment. Mask Seal Kit P/N 805655-01 may also
be required to attain a proper fit. Head harnesses are available in
several materials including polyester and Kevlar
1
. Each size facepiece
may be equipped with a lens kit if the use of corrective spectacles is
required. See ACCESSORIES Section for facepiece options.
The duration of the respirator may be extended by use of a low pres-
sure airline air supply. (For details see ACCESSORIES Section.) The
respirators are National Institute for Occupational Safety and Health
(NIOSH) approved for use in temperatures to -25 °F / -32 °C.
Depending on the cylinder and valve used, the respirators are ap-
proved and maintained under NIOSH approval numbers listed on the
NIOSH APPROVAL LABEL. These respirators meet the requirements
of Title 42, Part 84 of the Code of Federal Regulations when used
and maintained in accordance with these instructions and the NIOSH
label located on the harness and backframe assemblies. A complete
NIOSH APPROVAL LABEL is included with these instructions.
For assistance, contact your SCOTT authorized distributor or call
SCOTT Safety at 1-800-247-7257.
2
Portacount
Plus is a registered trademark of TSI Incorporated
EXPORT AND IMPORT
The international transport of this equipment is regulated under United
States export regulations and may be regulated by the import regula-
tions of other countries.
If you have any questions or concerns regarding these regulations,
contact SCOTT at 1-800-247-7257 (or 704-291-8300 outside the
continental United States).
QUESTIONS OR CONCERNS
If you have any questions or concerns regarding use of this equip-
ment, contact your authorized SCOTT distributor, or contact SCOTT
at 1-800-247-7257 (or 704-291-8300 outside the continental United
States).
