Installation: SLD150 Hotel Dispenser
Assembly
The ice machine must be placed onto the top of
the dispenser, and the bin thermostat capillary
tube routed into the bracket in the dispenser.
1. Check that the dispenser has a gasket all
around the perimeter of the top, 22" wide by 23"
deep.
2. Locate the inlet hole of the thermostat bracket,
and make sure that it is open.
3. Place a corner post from the ice machine carton
at the front of left and right sides of the hotel
dispenser top.
4. Use a mechanical lift and place the ice machine
onto the dispenser. The cardboard corner posts
should keep the front edge of the ice machine up.
5. Remove the front panel of the ice machine.
6. Locate the bin thermostat capillary tube and
uncoil about 18" of tubing.
7. Locate plastic tube in base of ice
machine, next to compressor and
push the end of the capillary tube thru
the tube, watch the capillary as it
comes out of the base, line it up with
the inlet hole of the thermostat
bracket and push it into the hole.
Move the cabinet of the ice machine
until the capillary tube is going
straight down into the inlet hole.
8. Carefully remove the corner posts.
9. Push the capillary tube into the
thermostat bracket tube until about
14" of capillary tube is in the tube.
9 Remove the hardware package
from the machine, remove brackets.
10. At the back of the dispenser,
fasten brackets to the ice machine.
11. Using brackets for templates, drill
1/8" holes into the back of the
dispenser.
12. Secure brackets to the dispenser
with sheet metal screws from the
hardware package.
13. Follow other installation
instructions from the SLD150.
Route Capillary Tube
Through Plastic
Tube In Base
Bin Thermostat
Bracket Mounted In
Dispenser
Bin Thermostat Capillary
Tube Installation
Temporarily
Support Machine
With Corner Posts
To Observe Cap
Tube Installation
SLE400
January 1995
Page 6
