Door swing change
Note: Prior models had separate hinge brackets
and different directions to change swing.
Moving the hinges allows the door to open from
either the left or right side. Change swing before
attaching door panel.
To change:
1.
Remove innermost screw holding each hinge
to cabinet, loosen the other.
2.
Slide door to the side and remove from cabinet.
3.
Remove plug and hinge pocket covers from
door.
Note: There are either plugs or screws in the holes
where the hinges will mount. They must be moved.
4.
Remove hole plugs or screws from unit's new
hinge locations, set aside.
5.
Move screws loosened in step 1 to opposite
location.
6.
Install screws or plugs removed in step 4 to the
unit's original hinge location to fill the holes.
7.
Remove the upper hinge from the door and
move it to the door's opposite side, bottom
location. Secure using the original screws.
Note: If door panel is attached, it must be removed
to access hinge screws and to reverse handle
position.
8.
Remove the original lower hinge and move it to
the door's opposite side, upper location.
Secure using the original screws.
9.
Install pocket covers and hole plugs onto door.
10. Attach the door to the cabinet using the original
screws.
Installation Notes
Built In Situations
: If a finished floor is to be
installed in the area after the ice machine has been
built in, shims the expected thickness of the floor
should be installed under the unit to keep the
machine level with the planned floor level.
Installations on a slab
: Use a pump model and
pump the water to the point of drainage. Pump
models will pump 1 story (10 feet) high.
Installations over a crawl space or basement
:
Either gravity drain or pump model units may be
used, if there is not enough room behind the
machine for a drain/waste receptacle, the drain will
have to be below the floor.
Note: When installed in a corner, the door swing
may be limited due to handle contact with the wall
or cabinet face.
January 2012
Page 6
SCCG50 & SCCP50 - Outdoor Model
Installation and User's Manual
Hole
Plug
Hole
Cover
