Electrical
The ice machine is supplied with a power cord. Do
not remove the grounding pin from the cord’s plug.
Do not use extension cords. Follow all codes.
Connect the machine to its own 115 volt, 15 amp
circuit.
1. If the electrical outlet for the ice maker is behind
the unit, plug in the unit.
2. Position the unit in the installation opening.
3. Turn on the water supply. Make sure that the ice
maker is plugged in and the power is on.
4. Slide unit into installation opening, paying careful
attention to water supply and drain connections. Do
not kink!
5. Pour a couple of quarts of water into the ice
storage bin; on units equipped with a drain pump
the drain pump should start and water should pump
out. Check for leaks and proper draining.
6. Replace the service access panel. Level the unit
as needed.
Installation check list:
Has the unit been connected to the proper water
supply?
Has the water supply be checked for leaks?
Has the unit been connected to a drain?
Has the drain been tested for flow and leaks?
Has the unit been connected to the proper
electrical supply?
Has the unit been leveled?
Have all packing materials been removed from the
machine?
Has the door covering been installed?
Initial Start Up
1. Turn on the water supply.
2. Switch on the electrical power.
3. Switch the on/off switch to On.
The compressor will start and water will begin to
flow into the unit. When the reservoir is full, water
will start to drain from the machine. After a few
minutes the water pump and fan motor will begin to
operate and the first ice making cycle will have
begun.
No adjustments are needed.
After about a half hour, ice will fall into the ice
storage bin. The first batches of ice will melt, this is
normal. It will take 24 to 36 hours of continuous run
time to fill the ice storage bin. When the bin is full of
ice, the ice machine will shut off. It will
automatically restart when the ice level falls, either
from use or meltage.
November 2009
Page 12
SCCG30 & SCCP30
User Manual
